For a management center high-availability pair, you also need to set the public IP address/FQDN
on the secondary management center. You can't set value this using CDO; you need to set it in
the secondary management center. See .
Note
Step 6 In Connection, enter the device's serial number and device name. Click Next.
Figure 46: Connection
Step 7 In Password Reset, click Yes.... Enter a new password and confirm the new password for the device, then
click Next.
For low-touch provisioning, the device must be brand new or has been reimaged.
If you did log into the device and reset the password, and you did not change the configuration
in a way that would disable low-touch provisioning, then you should choose the No... option.
There are a number of configurations that disable low-touch provisioning, so we don't recommend
logging into the device unless you need to, for example, to perform a reimage.
Note
Figure 47: Password Reset
Step 8 In Policy Assignment, use the drop-down menu to select an access control policy for the device. If you have
not added a policy on the management center, you should go to the management center and add one now.
Click Next.
Cisco Firepower 2100 Getting Started Guide
74
Threat Defense Deployment with a Remote Management Center
Add a Device to the Management Center Using Low-Touch Provisioning
To Next Page
Loading...
Need help?
General