Cisco Firepower 9300 Hardware Installation Guide

CHAPTER 2
Installation Preparation
• Installation Warnings, on page 43
• Safety Recommendations, on page 46
• Maintain Safety with Electricity , on page 46
• Prevent ESD Damage , on page 47
• Site Environment, on page 47
• Site Considerations, on page 47
• Power Supply Considerations, on page 48
• Rack Configuration Considerations, on page 48
Installation Warnings
Read the Regulatory and Compliance Safety Information document before installing the Firepower 9300.
Take note of the following warnings:
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Read the installation instructions before using, installing, or
connecting the system to the power source. Use the statement number provided at the end of each warning
statement to locate its translation in the translated safety warnings for this device.
SAVE THESE INSTRUCTIONS
Warning
Cisco Firepower 9300 Hardware Installation Guide
43

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes