Cisco Firepower 9300 Hardware Installation Guide

Cable distance
Half the
distance
specified by
the IEEE
standard.
Note
Modal bandwidth
(MHz/km)
Core diameter (microns)
13 m
16.5 m
33 m
41 m
150 m
200 m
160 (FDDI)
200 (OM1)
400
500 (OM2)
2000 (OM3)
4700 (OM4)
62.5
62.5
50
50
50
50
Cable and operating
distance
Table 5: 10-Gb LR Network Module (FPR9K-NM-6X10LR-F)
MaximumTypicalOperating Mode
1.6 dB
1.9 dB
1.2 dB
1.5 dB
Normal
Hardware bypass
Insertion loss
Cable distance
Half the
distance
specified by
the IEEE
standard.
Note
Modal bandwidth
(MHz/km)
Core diameter (microns)
5 kmSingle modeG.652Cable and operating
distance
Power Supply Modules
The Firepower 9300 supports two AC, two DC, or two high-voltage DC (HVDC) power supply modules so
that dual power supply redundancy protection is available. Facing the front of the chassis, the power supply
modules are numbered left to right, for example, PSU-1 and PSU-2.
Make sure that one power supply module is always active.
Attention
AC Power Supply Modules
The 220-V power supply modules run at 2500 W for 200 to 240 V AC. The load is shared when both
power supply modules are plugged in and running at the same time. The power supply modules support
Cisco Firepower 9300 Hardware Installation Guide
26
Overview
Power Supply Modules

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes