See the "Power Off/On an Installed Module/Engine" in the Security/Module/Engine Management chapter
of the FXOS CLI Configuration Guide for your software version for the procedure to shut down the
security modules gracefully using CLI commands from the Supervisor. When you see Oper Power: off
for all slots, you can move the power switch on the rear of the chassis to OFF.
See the "Power Off/On an Installed Security Module/Engine" topic in the Security Module/Engine
Management chapter of the FXOS Configuration Guide for your software version for the procedure to
shut down the security module from the Chassis Manager. After the shutdown is complete, you can move
the power switch on the rear of the chassis to OFF.
Deployment Options
Here are some examples of how you can deploy the Firepower 9300:
• At the core/aggregation layer of a three-tier data center in a high availability configuration.
• As a dedicated multifunction security service within converged infrastructure stacks (vBlock, FlexPod,
for example) at the access layer.
• As a high-performance data center security appliance between the WAN edge and data center core in an
high availability configuration.
• As a leaf that exclusively offers security functions in a spine/leaf data center design.
Package Contents
The following figure shows the package contents for the Firepower 9300. Note that the contents are subject
to change and your exact contents might contain additional or fewer items.
Cisco Firepower 9300 Hardware Installation Guide
6
Overview
Deployment Options
To Next Page
Loading...
Need help?
General
