Cisco Firepower 9300 Hardware Installation Guide

DescriptionFeature
On front panelLocator beacon
On rear panel
The initial Firepower 9300 chassis does not have a power switch.
Note
Power switch
Two
On rear panel
Power supply slots
AC, DC, and HVDC
Do not mix power supply types or wattage.
Note
Power supply types
Yes 1 + 1Redundant power
Four (hot-swappable)
On rear panel
Fan slots
SM-24, SM-36, SM-44—Up to 2.4 TB per chassis (1.2 TB per security module
in RAID 1 configuration)
SM-40, SM-48, SM-56—UP to 4.8 TB per chassis (1.6 TB per security module
in RAID 1 Configuration)
Storage
Chassis Components
The Firepower 9300 chassis contains the following components:
• Firepower 9300 Supervisor—Chassis supervisor module
• Management port
• RJ-45 console port
• USB Type A port
• Eight ports for 1- or 10-Gigabit Ethernet small form-factor pluggable (SFP) ports (fiber and copper)
• Firepower 9300 Security Module—Up to three security modules
• Firepower Network Module—Two single-wide network modules or one double-wide network module
• Two power supply modules (AC or DC)
• Four fan modules
Cisco Firepower 9300 Hardware Installation Guide
4
Overview
Chassis Components

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes