• Tech-support files
• Security module log files
• Platform bundle image upload using download image usbA:
The USB Type A port does not support Cisco Secure Package (CSP) image upload.
Network Ports
The Firepower 9300 chassis has eight ports that require SFP/SFP+/QSFP transceivers (fiber or copper).
They are numbered from left to right starting with 1 and are named Ethernet 1/1 through Ethernet 1/8.
The 9300 also has two network module slots that support different numbers of ports depending on the
network module. See Network Modules, on page 15 for the supported network modules. See for Supported
SFP/SFP+ and QSFP Transceivers, on page 28 the list of supported transceivers.
Each port has LEDs that represent link/activity status.
Management Port
The Firepower 9300 chassis has a management port on the Supervisor that requires a 1-Gb fiber or copper
SFP.
Security Modules
The Firepower 9300 has three slots for security modules. The security modules are hot-swappable.
Make sure you have the correct firmware package and software version installed to support your security
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade Guide. See Cisco Firepower 4100/9300
FXOS Compatibility for the software compatibility matrix.
Note
For FXOS software versions before version 2.6.1, all security modules in the chassis must be the same type;
you cannot mix security module types. For version 2.6.1 and later, you can mix different types of security
modules in the same chassis.
Note
Cisco Firepower 9300 Hardware Installation Guide
13
Overview
Security Modules
To Next Page
Loading...
Need help?
General
