14-43
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 14 Configuring Failover
Configuring Failover
RPC services 0 0 0 0
TCP conn 33 0 0 0
UDP conn 0 0 0 0
ARP tbl 12 0 0 0
Xlate_Timeout 0 0 0 0
GTP PDP 0 0 0 0
GTP PDPMCB 0 0 0 0
Table 14-8 Show Failover Display Description
Field Options
Failover
• On
• Off
Failover Unit Primary or Secondary.
Failover LAN Interface Displays the logical and physical name of the failover link.
Unit Poll frequency Displays the number of seconds between hello messages sent to the
peer unit and the number of seconds during which the unit must receive
a hello message on the failover link before declaring the peer failed.
Interface Poll frequency n seconds
The number of seconds you set with the failover polltime interface
command. The default is 15 seconds.
Interface Policy Displays the number or percentage of interfaces that must fail before
triggering failover.
Monitored Interfaces Displays the number of interfaces monitored out of the maximum
possible.
Group 1 Last Failover at:
Group 2 Last Failover at:
The date and time of the last failover for each group in the following
form:
hh:mm:ss UTC DayName Month Day yyyy
UTC (Coordinated Universal Time) is equivalent to GMT (Greenwich
Mean Time).
This host:
Other host:
For each host, the display shows the following information.
Role Primary or Secondary
System State
• Active or Standby Ready
• Active Time in seconds
Group 1 State
Group 2 State
• Active or Standby Ready
• Active Time in seconds
slot x Information about the module in the slot or empty.
To Next Page
Loading...
