Cisco FirePOWER ASA 5500 series

14-42
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 14 Configuring Failover
Configuring Failover
Group 1 State: Standby Ready
Active time: 190 (sec)
Group 2 State: Active
Active time: 3322 (sec)
slot 0: ASA-5530 hw/sw rev (1.0/7.0(0)79) status (Up Sys)
slot 1: SSM-IDS-20 hw/sw rev (1.0/5.0(0.1)S91(0.1)) status (Up)
admin Interface outside (10.132.8.6): Normal
admin Interface third (10.132.9.6): Normal
admin Interface inside (10.130.8.6): Normal
admin Interface fourth (10.130.9.6): Normal
ctx1 Interface outside (10.1.1.2): Normal
ctx1 Interface inside (10.2.2.2): Normal
ctx2 Interface outside (10.3.3.1): Normal
ctx2 Interface inside (10.4.4.1): Normal
Stateful Failover Logical Update Statistics
Link : third GigabitEthernet0/2 (up)
Stateful Obj xmit xerr rcv rerr
General 1973 0 1895 0
sys cmd 380 0 380 0
up time 0 0 0 0
RPC services 0 0 0 0
TCP conn 1435 0 1450 0
UDP conn 0 0 0 0
ARP tbl 124 0 65 0
Xlate_Timeout 0 0 0 0
VPN IKE upd 15 0 0 0
VPN IPSEC upd 90 0 0 0
VPN CTCP upd 0 0 0 0
VPN SDI upd 0 0 0 0
VPN DHCP upd 0 0 0 0
Logical Update Queue Information
Cur Max Total
Recv Q: 0 1 1895
Xmit Q: 0 0 1940
The following is sample output from the show failover group command for Active/Active Failover. The
information displayed is similar to that of the show failover command, but limited to the specified
group. Table 14-8 provides descriptions for the information shown.
hostname# show failover group 1
Last Failover at: 04:09:59 UTC Jan 4 2005
This host: Secondary
State: Active
Active time: 186 (sec)
admin Interface outside (192.168.5.121): Normal
admin Interface inside (192.168.0.1): Normal
Other host: Primary
State: Standby
Active time: 0 (sec)
admin Interface outside (192.168.5.131): Normal
admin Interface inside (192.168.0.11): Normal
Stateful Failover Logical Update Statistics
Status: Configured.