Cisco FirePOWER ASA 5500 series

14-41
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 14 Configuring Failover
Configuring Failover
Show Failover—Active/Active
The following is sample output from the show failover command for Active/Active Failover. Table 14-8
provides descriptions for the information shown.
hostname# show failover
Failover On
Failover unit Primary
Failover LAN Interface: third GigabitEthernet0/2 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 4 seconds
Interface Policy 1
Monitored Interfaces 8 of 250 maximum
failover replication http
Group 1 last failover at: 13:40:18 UTC Dec 9 2004
Group 2 last failover at: 13:40:06 UTC Dec 9 2004
This host: Primary
Group 1 State: Active
Active time: 2896 (sec)
Group 2 State: Standby Ready
Active time: 0 (sec)
slot 0: ASA-5530 hw/sw rev (1.0/7.0(0)79) status (Up Sys)
slot 1: SSM-IDS-20 hw/sw rev (1.0/5.0(0.11)S91(0.11)) status (Up)
admin Interface outside (10.132.8.5): Normal
admin Interface third (10.132.9.5): Normal
admin Interface inside (10.130.8.5): Normal
admin Interface fourth (10.130.9.5): Normal
ctx1 Interface outside (10.1.1.1): Normal
ctx1 Interface inside (10.2.2.1): Normal
ctx2 Interface outside (10.3.3.2): Normal
ctx2 Interface inside (10.4.4.2): Normal
Other host: Secondary
VPN IPSEC upd IPSec connection information.
VPN CTCP upd cTCP tunnel connection information.
VPN SDI upd SDI AAA connection information.
VPN DHCP upd Tunneled DHCP connection information.
GTP PDP GTP PDP update information. This information appears only if inspect
GTP is enabled.
GTP PDPMCB GTP PDPMCB update information. This information appears only if
inspect GTP is enabled.
Logical Update Queue
Information
For each field type, the following statistics are used:
• Cur—Current number of packets
• Max—Maximum number of packets
• Total—Total number of packets
Recv Q The status of the receive queue.
Xmit Q The status of the transmit queue.
Table 14-7 Show Failover Display Description (continued)
Field Options