40-12
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 40 Managing System Access
Configuring AAA for System Administrators
Figure 40-1 Permitting All Related Commands
• For commands that are a single word, you must permit unmatched arguments, even if there are no
arguments for the command, for example enable or help (see Figure 40-2).
Figure 40-2 Permitting Single Word Commands
•
To disallow some arguments, enter the arguments preceded by deny.
For example, to allow enable, but not enable password, enter enable in the commands box, and
deny password in the arguments box. Be sure to select the Permit Unmatched Args check box so
that enable alone is still allowed (see Figure 40-3).
To Next Page
Loading...
