Cisco IE-3000-8TC - Page 21

Contents
xxi
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Recovering from Flood Mode 25-12
Disabling Multicast Flooding During a TCN Event 25-13
Configuring the IGMP Snooping Querier 25-13
Disabling IGMP Report Suppression 25-15
Displaying IGMP Snooping Information 25-15
Understanding Multicast VLAN Registration 25-16
Using MVR in a Multicast Television Application 25-17
Configuring MVR 25-19
Default MVR Configuration 25-19
MVR Configuration Guidelines and Limitations 25-19
Configuring MVR Global Parameters 25-20
Configuring MVR Interfaces 25-21
Displaying MVR Information 25-23
Configuring IGMP Filtering and Throttling 25-23
Default IGMP Filtering and Throttling Configuration 25-24
Configuring IGMP Profiles 25-24
Applying IGMP Profiles 25-25
Setting the Maximum Number of IGMP Groups 25-26
Configuring the IGMP Throttling Action 25-27
Displaying IGMP Filtering and Throttling Configuration 25-28
CHAPTER 26 Configuring Port-Based Traffic Control 26-1
Configuring Storm Control 26-1
Understanding Storm Control 26-1
Default Storm Control Configuration 26-3
Configuring Storm Control and Threshold Levels 26-3
Configuring Small-Frame Arrival Rate 26-5
Configuring Protected Ports 26-6
Default Protected Port Configuration 26-6
Protected Port Configuration Guidelines 26-7
Configuring a Protected Port 26-7
Configuring Port Blocking 26-7
Default Port Blocking Configuration 26-7
Blocking Flooded Traffic on an Interface 26-8
Configuring Port Security 26-8
Understanding Port Security 26-9
Secure MAC Addresses 26-9
Security Violations 26-10