Contents
xxv
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Limiting TFTP Servers Used Through SNMP 33-16
SNMP Examples 33-17
Displaying SNMP Status 33-18
CHAPTER
34 Configuring Network Security with ACLs 34-1
Understanding ACLs 34-1
Port ACLs 34-2
Handling Fragmented and Unfragmented Traffic 34-3
Configuring IPv4 ACLs 34-4
Creating Standard and Extended IPv4 ACLs 34-5
Access List Numbers 34-6
Creating a Numbered Standard ACL 34-7
Creating a Numbered Extended ACL 34-8
Resequencing ACEs in an ACL 34-12
Creating Named Standard and Extended ACLs 34-12
Using Time Ranges with ACLs 34-14
Including Comments in ACLs 34-15
Applying an IPv4 ACL to a Terminal Line 34-16
Applying an IPv4 ACL to an Interface 34-16
Hardware and Software Treatment of IP ACLs 34-17
Troubleshooting ACLs 34-17
IPv4 ACL Configuration Examples 34-18
Numbered ACLs 34-19
Extended ACLs 34-19
Named ACLs 34-19
Time Range Applied to an IP ACL 34-20
Commented IP ACL Entries 34-20
Creating Named MAC Extended ACLs 34-20
Applying a MAC ACL to a Layer 2 Interface 34-22
Displaying IPv4 ACL Configuration 34-23
CHAPTER
35 Configuring Cisco IOS IP SLAs Operations 35-1
Understanding Cisco IOS IP SLAs 35-1
Using Cisco IOS IP SLAs to Measure Network Performance 35-2
IP SLAs Responder and IP SLAs Control Protocol 35-3
Response Time Computation for IP SLAs 35-4
Configuring IP SLAs Operations 35-5
Default Configuration 35-5
Configuration Guidelines 35-5
To Next Page
Loading...
