Contents
xxvii
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Enabling DSCP Transparency Mode 36-36
Configuring the DSCP Trust State on a Port Bordering Another QoS Domain 36-37
Configuring a QoS Policy 36-39
Classifying Traffic by Using ACLs 36-39
Classifying Traffic by Using Class Maps 36-42
Classifying, Policing, and Marking Traffic on Physical Ports by Using Policy Maps 36-44
Classifying, Policing, and Marking Traffic by Using Aggregate Policers 36-48
Configuring DSCP Maps 36-50
Configuring the CoS-to-DSCP Map 36-51
Configuring the IP-Precedence-to-DSCP Map 36-52
Configuring the Policed-DSCP Map 36-53
Configuring the DSCP-to-CoS Map 36-54
Configuring the DSCP-to-DSCP-Mutation Map 36-55
Configuring Ingress Queue Characteristics 36-56
Mapping DSCP or CoS Values to an Ingress Queue and Setting WTD Thresholds 36-57
Allocating Buffer Space Between the Ingress Queues 36-58
Allocating Bandwidth Between the Ingress Queues 36-59
Configuring the Ingress Priority Queue 36-60
Configuring Egress Queue Characteristics 36-61
Configuration Guidelines 36-61
Allocating Buffer Space to and Setting WTD Thresholds for an Egress Queue-Set 36-61
Mapping DSCP or CoS Values to an Egress Queue and to a Threshold ID 36-64
Configuring SRR Shaped Weights on Egress Queues 36-65
Configuring SRR Shared Weights on Egress Queues 36-66
Configuring the Egress Expedite Queue 36-67
Limiting the Bandwidth on an Egress Interface 36-67
Displaying Standard QoS Information 36-68
CHAPTER
37 Configuring IPv6 Host Functions 37-1
Understanding IPv6 37-1
IPv6 Addresses 37-2
Supported IPv6 Host Features 37-2
128-Bit Wide Unicast Addresses 37-3
DNS for IPv6 37-3
ICMPv6 37-3
Neighbor Discovery 37-3
IPv6 Stateless Autoconfiguration and Duplicate Address Detection 37-4
IPv6 Applications 37-4
Dual IPv4 and IPv6 Protocol Stacks 37-4
To Next Page
Loading...
