Cisco IE-3000-8TC - Page 847

Index
IN-15
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
IGMP snooping
and address aliasing 25-2
configuring 25-6
default configuration 25-6
definition 25-1
enabling and disabling 25-7
global configuration 25-7
Immediate Leave 25-5
method 25-8
monitoring 25-15
querier
configuration guidelines 25-13
configuring 25-13
supported versions 25-2
support for 1-3
VLAN configuration 25-7
IGMP throttling
configuring 25-27
default configuration 25-24
described 25-24
displaying action 25-28
Immediate Leave, IGMP 25-5
inaccessible authentication bypass 12-19
initial configuration
defaults 1-11
Express Setup 1-2
interface
range macros 13-8
interface command 13-5 to 13-6
interface configuration
REP 21-9
interface configuration mode 2-3
interfaces
auto-MDIX, configuring 13-16
configuration guidelines
duplex and speed 13-13
configuring
procedure 13-6
counters, clearing 13-19
interfaces (continued)
default configuration 13-10
described 13-17
descriptive name, adding 13-17
displaying information about 13-19
flow control 13-15
management 1-4
monitoring 13-18
naming 13-17
physical, identifying 13-5
range of 13-6
restarting 13-20
shutting down 13-20
speed and duplex, configuring 13-14
status 13-18
supported 13-4
types of 13-1
interfaces range macro command 13-8
interface types 13-5
Internet Protocol version 6
See IPv6
Intrusion Detection System
See IDS appliances
inventory management TLV 27-2, 27-6
IP ACLs
for QoS classification 36-7
implicit deny 34-7, 34-11
implicit masks 34-7
named 34-12
undefined 34-17
IP addresses
128-bit 37-2
candidate or member 7-3, 7-12
cluster access 7-2
command switch 7-3, 7-10, 7-12
discovering 8-27
IPv6 37-2
redundant clusters 7-10
standby command switch 7-10, 7-12