Cisco IE-3000-8TC - Page 849

Index
IN-17
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
IPv6
addresses 37-2
address formats 37-2
applications 37-4
assigning address 37-6
autoconfiguration 37-4
configuring static routes 37-9
default configuration 37-6
defined 37-1
forwarding 37-6
ICMP 37-3
monitoring 37-10
neighbor discovery 37-3
Stateless Autoconfiguration 37-4
supported features 37-2
understanding static routes 37-5
J
join messages, IGMP 25-3
L
LACP
See EtherChannel
Layer 2 frames, classification with CoS 36-2
Layer 2 interfaces, default configuration 13-10
Layer 2 traceroute
and ARP 39-11
and CDP 39-10
broadcast traffic 39-10
described 39-10
IP addresses and subnets 39-11
MAC addresses and VLANs 39-11
multicast traffic 39-11
multiple devices on a port 39-11
unicast traffic 39-10
usage guidelines 39-10
Layer 3 interfaces
assigning IPv6 addresses to 37-7
Layer 3 packets, classification methods 36-2
LDAP 6-2
Leaking IGMP Reports 22-4
LEDs, switch
See hardware installation guide
lightweight directory access protocol
See LDAP
line configuration mode 2-3
Link Aggregation Control Protocol
See EtherChannel
link failure, detecting unidirectional 19-7
link fault alarm 3-3
link integrity, verifying with REP 21-3
Link Layer Discovery Protocol
See CDP
link local unicast addresses 37-3
link redundancy
See Flex Links
links, unidirectional 29-1
link-state tracking
configuring 38-20
described 38-18
LLDP
configuring 27-4
characteristics 27-5
default configuration 27-4
enabling 27-5
monitoring and maintaining 27-10
overview 27-1
supported TLVs 27-2
switch stack considerations 27-2
transmission timer and holdtime, setting 27-5
LLDP-MED
configuring
procedures 27-4
TLVs 27-6