Cisco IP Communicator Administration Guide

4-5
Cisco IP Communicator Administration Guide for Cisco CallManager
OL-4698-01
Chapter 4 Configuring the Application
An Overview of Post-Installation Configuration Tasks
Related Topics
• Understanding Post-Installation Configuration Tasks, page 4-6
• Helping Users with Post-Installation Configuration Tasks, page 4-19
• Customizing Cisco IP Communicator, page 6-1
• Troubleshooting Cisco IP Communicator, page 8-1
Table 4-2 Recommended or optional post-installation configuration tasks
Task Required? Who configures where? For details, see...
Modify advanced
audio properties
Optional; used to
improve sound quality.
Recommended for
advanced users.
Cisco IP Communicator
right-click menu:
Preferences > Audio >
Advanced.
Configuring Settings for
Remote Use, page 4-17
Specify
low-bandwidth
setting for remote
use
Optional. Remote users
with low bandwidth
connections might
experience better audio
quality using a
low-bandwidth codec.
Cisco IP Communicator
right-click menu:
Preferences > Audio.
Configuring Settings for
Remote Use, page 4-17
Configure a custom
audio port range
Optional. You might
use this option if you
want to open up a single
port to pass audio
through a firewall or
want to apply a QoS
policy using a restricted
range of RTP ports.
Cisco IP Communicator
right-click menu:
Preferences > Audio >
Network...
Or, from Cisco CallManager
Administration: Phone
Configuration > Product
Specific Configuration.
Note that local configuration
takes precedent over
configuration done from
Cisco CallManager.
Selecting an Audio Port
Range, page 4-16

Cisco IP Communicator Specifications

General

Brand	Cisco
Model	IP Communicator
Category	Software
Language	English