Chapter 4 Configuring the Application
Understanding Post-Installation Configuration Tasks
4-6
Cisco IP Communicator Administration Guide for Cisco CallManager
OL-4698-01
Understanding Post-Installation Configuration Tasks
The following topics provide more detail about required and recommended
post-installation configuration tasks, as outlined in Table 4-1 and Table 4-2:
• Required Post-Installation Tasks, page 4-6
• Recommended or Optional Post-Installation Tasks, page 4-14
• Configuring Settings for Remote Use, page 4-17
• Understanding Local Configuration, page 4-19
Required Post-Installation Tasks
Required post-installation tasks are defined as those that might be necessary
before Cisco IP Communicator can function properly or before a user can access
important features.
Refer to the following sections for more information:
• Selecting and Tuning Audio Devices, page 4-6
• Specifying a TFTP Server, page 4-8
• Selecting a Device Name, page 4-9
• Resolving Audio IP Address Auto-Detection Problems, page 4-11
• Providing Password Information, page 4-13
Selecting and Tuning Audio Devices
The first time Cisco IP Communicator runs, users are prompted to select and tune
audio devices using the Audio Tuning Wizard. Users must complete this task
before Cisco IP Communicator will launch.
Users are not prompted to use Audio Tuning Wizard again unless the audio device
that they try to select by other means cannot be found (because it has not yet been
tuned), or in cases where users directly modify the volume on an audio device.
Users can launch the Wizard manually from the right-click menu in
Cisco IP Communicator interface or from the Windows Start menu.
To Next Page
Loading...
