Procedure
Step 1 Connect the USB drive to your local machine and format it with the FAT32 file system.
Step 2 Copy the compressed boot file to the USB drive.
Step 3 Verify that the copy operation is successful. To verify, compare the file size at source and destination. Also,
verify the MD5 checksum value.
Step 4 Extract the content of the compressed boot file by unzipping it in the USB drive. This makes the USB drive
a bootable drive.
The content of the zipped file ("EFI" and "boot" directories) must be extracted directly in the root
folder of the USB drive. If the unzipping application places the extracted files in a new folder, move
the "EFI" and "boot" directories to the root folder of the USB drive.
Note
Step 5 Insert the USB drive in one of the USB ports of NCS 1002.
Step 6 Reboot NCS 1002 using power cycle or console.
Step 7 Press Esc to enter BIOS.
Step 8 Select the Save & Exit tab of BIOS.
Step 9 Choose UEFI based USB device.
The system detects USB and boots the image from USB.
Admin Console:
GNU GRUB version 2.00
Press F2 to goto grub Menu..
Booting from USB..
Loading Kernel..
Validating End Entity Certificate...
Validating SubCA Certificate...
System Setup and Software Installation Guide for Cisco NCS 1002
5
Bring-up Cisco NCS 1002
Boot NCS 1002 Using USB Drive
To Next Page
Loading...
Need help?
General
