Cisco NCS 1002 System Setup And Software Installation Guide

• Verify whether the management interface is in the no shut state using the show running-config interface
mgmtEth command.
The following example shows sample output from the show running-config interface mgmtEth
command.
RP/0/RP0/CPU0:ios#show running-config interface mgmtEth 0/RP0/CPU0/0
Fri Nov 13 19:42:54.368 UTC
interface MgmtEth0/RP0/CPU0/0
ipv4 address 10.58.227.183 255.255.255.0
!
In the above output, the management interface is in the no shut state.
Verify Alarms
You can view the alarm information using the show alarms command.
Procedure
show alarms [ brief [ card | rack | system ] [ location location ] [ active | history ] | detail
[ card | rack | system ] [ location location ] [ active | clients | history | stats ] ]
Displays alarms in brief or detail.
Example:
RP/0/RP0/CPU0:ios# show alarms brief card location 0/RP0/CPU0 active
Thu Mar 8 17:51:47.237 UTC
------------------------------------------------------------------------------------
Active Alarms
------------------------------------------------------------------------------------
Location Severity Group Set Time Description
------------------------------------------------------------------------------------
0/0 Minor Slice 03/07/2018 07:33:43 UTC Encrypted Slice
Is Provisioned Without K9sec Package Or K9sec Package Incomplete
0/0 Critical Controller 03/07/2018 07:37:19 UTC Optics0/0/0/10 -
Improper Removal
0/0 Critical Controller 03/07/2018 07:38:17 UTC Optics0/0/0/2 -
Improper Removal
0/0 Critical Controller 03/07/2018 07:38:17 UTC Optics0/0/0/3 -
Improper Removal
0/0 Major Ethernet 03/07/2018 08:36:11 UTC
HundredGigECtrlr0/0/0/11 - Remote Fault
System Setup and Software Installation Guide for Cisco NCS 1002
29
Perform Preliminary Checks
Verify Alarms

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English