commit-Saves the configuration changes and remains within the configuration session.
end-Prompts user to take one of these actions:
• Yes-Saves configuration changes and exits the configuration session.
• No-Exits the configuration session without committing the configuration changes.
• Cancel-Remains in the configuration session, without committing the configuration changes.
What to do next
• Create user group that includes the user created in this task. See Create a User Group, on page 39.
• Create command rules that apply to the user group. See Create Command Rules, on page 40.
• Create data rules that apply to the user group. See Create Data Rules, on page 43.
Create a User Group
Create a new user group to associate command rules and data rules with it. The command rules and data rules
are enforced on all users that are part of the user group.
The NCS 1002 supports a maximum of 32 user groups.
Before you begin
Create a user profile. See Create a User Profile, on page 37.
Procedure
Step 1 admin
Example:
RP/0/RP0/CPU0:ios# admin
Enters System Admin EXEC mode.
Step 2 configure
Example:
sysadmin-vm:0_RP0# configure
Enters System Admin Config mode.
Step 3 aaa authentication groups group group_name
Example:
sysadmin-vm:0_RP0#(config)#aaa authentication groups group gr1
Creates a new user group (if it is not already present) and enters the group configuration mode. In this example,
the user group "gr1" is created.
System Setup and Software Installation Guide for Cisco NCS 1002
39
Create User Profiles and Assign Privileges
Create a User Group
To Next Page
Loading...
Need help?
General
