Cisco NCS 1002 System Setup And Software Installation Guide

sysadmin-vm:0_RP0# show hw-module fpd
Wed Feb 28 03:35:09.566 UTC
FPD Versions
===============
Location Card type HWver FPD device ATR Status Run Programd
-------------------------------------------------------------------------------
0/0 NCS1002-K9 0.1 CTRL_BKP_LOW B CURRENT 2.23
0/0 NCS1002-K9 0.1 CTRL_BKP_UP B CURRENT 2.23
0/0 NCS1002-K9 0.1 CTRL_FPGA_LOW CURRENT 2.23 2.23
0/0 NCS1002-K9 0.1 CTRL_FPGA_UP CURRENT 2.23 2.23
0/RP0 NCS1K-CNTLR 0.1 BIOS_Backup BS CURRENT 14.00
0/RP0 NCS1K-CNTLR 0.1 BIOS_Primary S CURRENT 14.40 14.40
0/RP0 NCS1K-CNTLR 0.1 Daisy_Duke_BKP BS CURRENT 0.15
0/RP0 NCS1K-CNTLR 0.1 Daisy_Duke_FPGA S CURRENT 0.17 0.17
0/PM0 NCS1K-2KW-AC 0.0 PO-PriMCU CURRENT
0/PM1 NCS1K-2KW-AC 0.0 PO-PriMCU CURRENT 4.00 4.00
FPD Automatic Upgrade
FPD automatic upgrade feature upgrades the FPD firmware version of all the components to the latest version
along with software activation. After the software upgrade, all the FPD components are in CURRENT status,
which can be checked using the show hw-module fpd command.
Once the FPD is upgraded, the FPD version is not downgraded to the previous version even if the image is
rolled back to the original version.
You can enable the FPD automatic upgrade feature using the following commands.
RP/0/RP0/CPU0:ios# conf
RP/0/RP0/CPU0:ios(config)# fpd auto-upgrade enable
RP/0/RP0/CPU0:ios(config)#commit
RP/0/RP0/CPU0:ios(config)#end
To verify if the FPD automatic upgrade feature is enabled, examine the output of the show running-config
command.
RP/0/RP0/CPU0:ios#
RP/0/RP0/CPU0:ios#show running-config | inc fpd
Thu Jul 5 15:42:02.502 IST
Building configuration...
fpd auto-upgrade enable
Example
The following example shows how to enable the FPD automatic upgrade feature.
RP/0/RP0/CPU0:ios#conf
RP/0/RP0/CPU0:ios(config)#fpd auto-upgrade enable
RP/0/RP0/CPU0:ios(config)#commit
RP/0/RP0/CPU0:ios(config)#end
The following example shows the output of show running-config command after enabling the FPD automatic
upgrade feature.
RP/0/RP0/CPU0:ios#
RP/0/RP0/CPU0:ios#show running-config | inc fpd
Thu Jul 5 15:42:02.502 IST
Building configuration...
fpd auto-upgrade enable
System Setup and Software Installation Guide for Cisco NCS 1002
60
Perform System Upgrade and Install Feature Packages
FPD Automatic Upgrade

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English