Cisco NCS 1002 System Setup And Software Installation Guide

• Cancel-Remains in the configuration session, without committing the configuration changes.
What to do next
Configure Telnet, on page 14 and Configure SSH, on page 15.
Configure Telnet
With a terminal emulation program, establish a telnet session to the management interface port using its IP
address.
Procedure
Step 1 configure
Example:
RP/0/RP0/CPU0:ios# configure
Enters the Configuration mode.
Step 2 telnet {ipv4 | ipv6} server max-servers limit
Example:
RP/0/RP0/CPU0:ios(config)# telnet ipv4 server max-servers 10
Specifies the number of allowable Telnet servers. Up to 100 Telnet servers are allowed. By default, no Telnet
servers are allowed. You must configure this command to enable the use of Telnet servers.
Step 3 Use the commit or end command.
commit-Saves the configuration changes and remains within the configuration session.
end-Prompts user to take one of these actions:
• Yes-Saves configuration changes and exits the configuration session.
• No-Exits the configuration session without committing the configuration changes.
• Cancel-Remains in the configuration session, without committing the configuration changes.
What to do next
Configure SSH, on page 15
System Setup and Software Installation Guide for Cisco NCS 1002
14
Bring-up Cisco NCS 1002
Configure Telnet

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English