Cisco NCS 1002 System Setup And Software Installation Guide

CHAPTER 1
Cisco NCS 1002 Product Overview
The Cisco Network Convergence System (NCS) 1002 is a 2 RU system that delivers fully programmable,
high-bandwidth capacity (up to 250 Gbps) wavelengths over distances exceeding 3000 km using existing
fiber. Powered by the industry-leading Cisco IOS XR operating system, Cisco NCS 1002 offers robust functions
such as third party application hosting, machine-to-machine interface, telemetry and flexible package delivery.
NCS 1002 delivers the following benefits:
• Supports up to 2 Tbps capacity
• Transports 100, 200, or 250Gbps per wavelength on the same platform through software provisioning
• Transports 10 GE, 40 GE, and 100 GE on the same platform through software provisioning
• Supports grid-less tuning for flex-grid dense wavelength-division multiplexing (DWDM)
• Supports different modulation formats (PM-QPSK or PM-16QAM)
• Supports 7% or 20% Soft Decision (SD) FEC for maximum optical performance
• Allows for automated installation, configuration and monitoring
• Supports machine-to-machine (M2M) APIs based on YANG models for ease of configuration
• Supports a telemetry agent for a pub-sub model of device monitoring
• Command Modes, on page 1
Command Modes
The Cisco NCS 1002 system runs on the Cisco IOS XR operating system. This table lists command modes.
DescriptionCommand Mode
Displays and monitors the operational state in XR mode.
Example:
RP/0/RP0/CPU0:ios#
XR execution mode
System Setup and Software Installation Guide for Cisco NCS 1002
1

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English