Cisco NCS 1002 System Setup And Software Installation Guide

Internet address is 10.77.132.68/24
MTU 1514 bytes, BW 100000 Kbit (Max: 100000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA,
Full-duplex, 100Mb/s, CX, link type is autonegotiation
loopback not set,
Last link flapped 1d21h
ARP type ARPA, ARP timeout 04:00:00
Last input 00:00:00, output 00:02:38
Last clearing of "show interface" counters never
5 minute input rate 2000 bits/sec, 4 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
852455 packets input, 58601651 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 560680 broadcast packets, 290268 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
1561 packets output, 93270 bytes, 0 total output drops
Output 0 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
In the above result, the management interface is administratively down.
You can also use the show interfaces summary and show interfaces brief commands in the Cisco IOS XR
EXEC mode to verify the management interface status.
• The following example shows sample output from the show interfaces summary command.
RP/0/RP0/CPU0:ios# show interfaces summary
Wed Feb 28 03:30:41.991 UTC
Interface Type Total UP Down Admin Down
-------------- ----- -- ---- ----------
ALL TYPES 4 2 0 2
--------------
IFT_ETHERNET 3 1 0 2
IFT_NULL 1 1 0 0
• The following example shows sample output from the show interfaces brief command.
RP/0/RP0/CPU0:ios# show interfaces brief
Wed Feb 28 03:30:47.996 UTC
Intf Intf LineP Encap MTU BW
Name State State Type (byte) (Kbps)
--------------------------------------------------------------------------------
Nu0 up up Null 1500 0
Mg0/RP0/CPU0/0 up up ARPA 1514 100000
Mg0/RP0/CPU0/1 admin-down admin-down ARPA 1514 1000000
Mg0/RP0/CPU0/2 admin-down admin-down ARPA 1514 1000000
What to do next
If the management interface is administratively down, perform the following steps:
• Check the Ethernet cable connection.
• Verify the IP configuration of the management interface. For details on configuring the management
interface, see the Bring-up NCS 1002 chapter.
System Setup and Software Installation Guide for Cisco NCS 1002
28
Perform Preliminary Checks
Verify Management Interface Status

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English