Cisco Nexus 5500 Series - Page 286

1280
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface brief
Eth1/27 1 eth access down SFP not inserted 10G(D) --
Eth1/28 1 eth access down SFP not inserted 10G(D) --
Eth1/29 1 eth access down Link not connected 10G(D) --
Eth1/30 1 eth access down SFP not inserted 10G(D) --
Eth1/31 1 eth access down SFP not inserted 10G(D) --
Eth1/32 1 eth access up none 10G(D) --
--------------------------------------------------------------------------------
Port-channel VLAN Type Mode Status Reason Speed Protocol
Interface
--------------------------------------------------------------------------------
Po100 1 eth trunk up none a-10G(D) none
--------------------------------------------------------------------------------
Port VRF Status IP Address Speed MTU
--------------------------------------------------------------------------------
mgmt0 -- up 192.0.2.33 1000 1500
-------------------------------------------------------------------------------
Interface Secondary VLAN(Type) Status Reason
-------------------------------------------------------------------------------
Vlan1 -- up --
Vlan100 -- up --
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth100/1/1 1 eth access up none 10G(D) --
Eth100/1/2 1 eth access down Link not connected auto(D) --
Eth100/1/3 1 eth access up none 10G(D) --
Eth100/1/4 1 eth access down Link not connected auto(D) --
Eth100/1/5 1 eth access down Link not connected auto(D) --
Eth100/1/6 1 eth access down Link not connected auto(D) --
Eth100/1/7 1 eth access down Link not connected auto(D) --
Eth100/1/8 1 eth access down Link not connected auto(D) --
Eth100/1/9 1 eth access down Link not connected auto(D) --
Eth100/1/10 1 eth access up none 10G(D) --
Eth100/1/11 1 eth access down Link not connected auto(D) --
Eth100/1/12 1 eth access down Link not connected auto(D) --
Eth100/1/13 1 eth access down Link not connected auto(D) --
Eth100/1/14 1 eth access down Link not connected auto(D) --
Eth100/1/15 1 eth access up none 10G(D) --
Eth100/1/16 1 eth access down Link not connected auto(D) --
--------------------------------------------------------------------------------
Interface Status Description
--------------------------------------------------------------------------------
Lo10 up --
switch#
Note the following in the above display:
• Ethernet 1/5 is a Layer 3-ready interface. The following fields in the display help identify an
interface as a configured Layer 3 interface:
– Mode—routed
– Status—up
– Reason—none
• Ethernet 1/5.2 is a Layer 3 subinterface; however, the interface is not ready for Layer 3 configuration
(Status—down).