1281
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface brief
• Interface Lo10 is a Layer 3 loopback interface.
This example shows how to display a brief summary of interfaces configured as FabricPath interfaces:
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch#
--------------------------------------------------------------------------------
Eth1/1 1 eth access down SFP not inserted 1000(D) --
Eth1/2 -- eth routed down SFP not inserted 1000(D) --
Eth1/3 1 eth access down SFP not inserted 10G(D) --
Eth1/4 1 eth access down SFP not inserted 10G(D) --
Eth1/5 1 eth f-path down SFP not inserted 10G(D) --
Eth1/6 1 eth access down Link not connected 10G(D) --
Eth1/7 1 eth fabric down Link not connected 10G(D) --
Eth1/8 1 eth access down SFP not inserted 10G(D) --
Eth1/9 1 eth access down SFP not inserted 10G(D) --
Eth1/10 1 eth access down SFP not inserted 10G(D) --
Eth1/11 1 eth access down SFP not inserted 10G(D) --
Eth1/12 1 eth access down SFP not inserted 10G(D) --
Eth1/13 1 eth access down SFP not inserted 10G(D) --
Eth1/14 1 eth access down SFP not inserted 10G(D) --
Eth1/15 1 eth pvlan up none 1000(D) --
Eth1/16 1 eth access down SFP not inserted 10G(D) --
Eth1/17 1 eth access down SFP not inserted 10G(D) --
switch#
In the above display, Ethernet 1/5 has the mode shown as “f-path” indicating that it has been configured
as a FabricPath port.
Related Commands Command Description
interface ethernet Configures an Ethernet IEEE 802.3 interface.
To Next Page
Loading...
