Cisco Nexus 5500 Series - Page 288

1282
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface capabilities
show interface capabilities
To display detailed information about the capabilities of an interface, use the show interface
capabilities command.
show interface ethernet slot/[QSFP-module/]port capabilities
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines You can use the show interface capabilities command only for physical interfaces.
Examples This example shows how to display the interface capabilities for a specific interface:
switch# show interface ethernet 1/1 capabilities
Ethernet1/1
Model: N6K-C6004-M12Q-FIX
Type (SFP capable): unknown
Speed: 40000
Duplex: full
Trunk encap. type: 802.1Q
Channel: yes
Broadcast suppression: no
Flowcontrol: rx-(off/on),tx-(off/on)
Rate mode: none
QOS scheduling: rx-(6q1t),tx-(1p6q0t)
CoS rewrite: no
ToS rewrite: no
SPAN: yes
UDLD: yes
MDIX: no
Link Debounce: yes
Link Debounce Time: yes
Pvlan Trunk capable: yes
TDR capable: no
ethernet
slot/[QSFP-module/]port
Specifies an Ethernet interface slot number and port number. The slot
number is from 1 to 255. The QSFP-module number is from 1 to 4.
The port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.