Cisco Nexus 5500 Series - Page 317

1311
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface vethernet counters
show interface vethernet counters
To display information about the virtual Ethernet (vEth) interface counters, use the show interface
vethernet counters command.
show interface vethernet veth-id counters [brief | detailed [all] [snmp] | errors [snmp] | snmp]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display a brief information about the counters configured on a specified
virtual Ethernet interface:
switch# show interface vethernet 10 counters brief
-------------------------------------------------------------------------------
Interface Input Rate (avg) Output Rate (avg)
------------------ ------------------
Rate Total Rate Total Rate averaging
MB/s Frames MB/s Frames interval (seconds)
-------------------------------------------------------------------------------
Vethernet10 0 0 0 0
switch#
Related Commands
veth-id Virtual Ethernet interface number. The range is from 1 to 1,048,575.
brief (Optional) Displays brief information about the vEth interface counters.
detailed (Optional) Displays detailed information of only the nonzero vEth interface
counters.
all (Optional) Displays all nonzero vEth interface counters.
errors (Optional) Displays the vEth interface error counters, such as receive or
transmit error counters.
snmp (Optional) Displays the Simple Network Management Protocol (SNMP)
MIB values for the nonzero vEth interface counters.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
interface vethernet Configures a virtual Ethernet interface.