Cisco Nexus 5500 Series - Page 318

1312
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface virtual
show interface virtual
To display the status of all virtual interfaces, use the show interface virtual command.
show interface virtual {{status | summary} [adapter-fex | bound interface ethernet
slot/[QSFP-module/]port | vm-fex]}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines Before you use this command, make sure that you enable Cisco Virtual Machine Fabric Extender
(VM-FEX) on the switch by using the feature vmfex command.
Examples This example shows how to display brief information about the counters configured on a specified virtual
Ethernet interface:
switch# show interface virtual status
Interface VIF-index Bound If Chan Vlan Status Mode Vntag
-------------------------------------------------------------------------
Total 1 Veth interfaces
switch#
status Displays the status of all virtual Ethernet interfaces (vEth) and floating
virtual interfaces.
summary Displays the summary information about virtual Ethernet interfaces.
adapter-fex (Optional) Displays information about fixed virtual ethernet interfaces.
bound interface (Optional) Displays information about virtual interfaces on a bound
interface.
ethernet
slot/[QSFP-module/]port
(Optional) Displays information about a specific ethernet interface.The
slot number is from 1 to 255. The QSFP-module number is from 1 to
4. The port number is from 1 to 128.
Note The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
vm-fex (Optional) Displays information about all floating virtual interfaces.
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.