Cisco Nexus 5500 Series - errdisable recovery interval

150
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter E Commands
errdisable recovery interval
errdisable recovery interval
To configure the recovery time interval to bring the interface out of the error-disabled (err-disabled)
state, use the errdisable recovery interval command. To revert to the defaults, use the no form of this
command.
errdisable recovery interval time
no errdisable recovery interval
Syntax Description
Command Default Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines When error disable recovery is enabled, the interface automatically recovers from the err-disabled state,
and the device retries bringing the interface up.
The device waits 300 seconds to retry.
Examples This example shows how to enable error disable recovery time interval to 100 seconds:
switch(config)# errdisable recovery interval 100
switch(config)#
Related Commands
time Error disable recovery time interval. The range is from 30 to 65535 seconds.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
errdisable recovery
cause
Enables an error disabled recovery on an interface.
show interface status
err-disabled
Displays the interface error disabled state.