Cisco Nexus 5500 Series - Page 57

151
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter E Commands
erspan-id
erspan-id
To configure the flow ID for an Encapsulated Remote Switched Port Analyzer (ERSPAN)) session, use
the erspan-id command. To remove the flow ID, use the no form of this command.
erspan-id flow_id
Syntax Description
Command Default None
Command Modes ERSPAN session configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the flow ID for an ERSPAN session:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# erspan-id 100
switch(config-erspan-src)#
Related Commands
flow_id ERSPAN flow ID. The range is from 1 to 1023.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
ip dscp Configures the DSCP value of the packets in the ERSPAN traffic.
ip ttl Configures the IP time-to-live (TTL) value of the ERSPAN traffic.
mtu Sets the maximum transmission unit (MTU) size for SPAN packet.
vrf Configures the VRF for ERSPAN traffic forwarding.
monitor-session Enters the monitor configuration mode for configuring an ERSPAN or
SPAN session for analyzing traffic between ports.