154
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter F Commands
feature flexlink
feature flexlink
To enable Flex Links, use the feature flexlink command. To disable Flex Links, use the no form of this
command.
feature flexlink
no feature flexlink
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Command History
Examples This example shows how to enable Flex Links on the switch:
switch(config)# feature flexlink
Related Commands
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
show feature Displays the status of features enabled or disabled on the switch.
switchport backup
interface
Configures Flex Links, which are two interfaces that provide backup to each
other, on a Layer 2 interface.
To Next Page
Loading...
