Cisco Nexus 5500 Series - Page 71

165
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter F Commands
feature-set virtualization
feature-set virtualization
To enable the Cisco Virtual Machine features on the switch, use the feature-set virtualization
command. To disable the virtualization feature, use the no form of this command.
feature-set virtualization
no feature-set virtualization
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines
Note The Cisco virtual machine feature is supported only on the Cisco Nexus devices.
Before you use this command, make sure that you install the virtualization feature set on the switch by
using the install feature-set virtualization command.
You cannot view or access any virtualization commands until you enable a Cisco virtual machine on the
switch.
Note You must install the Cisco virtual machine feature set before you enable virtualization on the switch.
Before you disable this feature on the switch, do the following:
• Remove all virtual Ethernet interface configurations on the switch.
• Remove all virtual network tag (VNTag) configurations on the switch.
• Remove all port profiles of type vethernet.
• Change the port mode to access by using the switchport mode access command.
This command requires an Enhanced Layer 2 license.
Examples This example shows how to enable the virtualization feature on the switch:
switch# configure terminal
switch(config)# feature-set virtualization
Release Modification
5.2(1)N1(1) This command was introduced.