Cisco ONS 15454 - Monitoring and Verifying Tunneling Status

8-9
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Chapter 8 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
Configuring Layer 2 Protocol Tunneling
Monitoring and Verifying Tunneling Status
Table 8-2 shows the privileged EXEC commands for monitoring and maintaining IEEE 802.1Q and
Layer 2 protocol tunneling.
Step 8
Router(config-if)# exit
Returns to global configuration mode.
Step 9
Router(config-if)# end
Returns to privileged EXEC mode.
Step 10
Router# show dot1q-tunnel
Displays the tunnel ports on the switch.
Step 11
Router# copy running-config
startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
Table 8-2 Commands for Monitoring and Maintaining Tunneling
Command Purpose
show dot1q-tunnel
Displays IEEE 802.1Q tunnel ports on the switch.
show dot1q-tunnel interface interface-id
Verifies if a specific interface is a tunnel port.
show l2protocol-tunnel
Displays information about Layer 2 protocol
tunneling ports.
show vlan
Displays IEEE 802.1Q tunnel information.