Cisco ONS 15454 - Displaying ML-Series Ethernet Ports Provisioning Information on CTC; Figure

2-5
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Chapter 2 CTC Operations
Displaying ML-Series Ethernet Ports Provisioning Information on CTC
Displaying ML-Series Ethernet Ports Provisioning Information
on CTC
The Ethernet port provisioning window (Figure 2-3 on page 2-6) displays the provisioning status of the
card’s Ethernet ports. Click the Provisioning > Ether Ports tabs to display this window. For ML-Series
cards, only the Port Name field can be provisioned from CTC. The user must configure ML-Series ports
through the Cisco IOS CLI.
Rx Runts Total number of frames received that are less than 64 bytes in length and
have a CRC error
Rx Longs Counter for the number of received frames that exceed the maximum valid
packet length of 1518 bytes
Rx Total Errors Total number of receive errors
Rx Crc Errors Number of packets with a CRC error
Rx Input Drop Packets Number of received packets dropped on input
Rx Input Abort Packets Number of received packets aborted on input
Tx Pre Hdlc Bytes Number of bytes transmitted prior to the bytes undergoing HLDC
encapsulation by the policy engine
Tx Post Hdlc Bytes Number of bytes transmitted after the bytes undergoing HLDC
encapsulation by the policy engine
Tx Packets Number of packets transmitted since the last counter reset
Port Drop Counts Number of received frames dropped at the port level
Table 2-4 POS Parameters (continued)
Parameter Meaning