CHAPTER
2-1
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
2
CTC Operations
This chapter covers Cisco Transport Controller (CTC) operations of the ML-Series card. All operations
described in the chapter take place at the card-level view of CTC. CTC shows provisioning information
and statistics for both the Ethernet and paket over SONET/SDH (POS) ports of the ML-Series card. For
the ML-Series cards, CTC manages SONET/SDH alarms and provisions STS/STM circuits in the same
manner as other ONS 15454 SONET/SDH traffic cards.
For information on using CTC to load a Cisco Internet Operating System (IOS) configuration file or to
open a Cisco IOS command line interface (CLI) session, see Loading a Cisco IOS Startup Configuration
File Through CTC, page 3-9 or Opening a Cisco IOS Session Using CTC, page 3-2.
This chapter contains the following major sections:
• Displaying ML-Series Ethernet Statistics on CTC, page 2-1
• Displaying ML-Series POS Statistics on CTC, page 2-3
• Displaying ML-Series Ethernet Ports Provisioning Information on CTC, page 2-5
• Displaying ML-Series POS Ports Provisioning Information on CTC, page 2-7
• Managing SONET/SDH Alarms, page 2-8
• SONET/SDH Circuit Provisioning, page 2-9
Displaying ML-Series Ethernet Statistics on CTC
The Ethernet statistics window (Figure 2-1 on page 2-2) lists Ethernet port-level statistics. The
ML-Series Ethernet ports are zero based. Display the CTC card view for the ML-Series card and click
the Performance > Ether Ports tabs to display the window. Table 2-1 on page 2-2 describes the buttons
in the window. Table 2-2 on page 2-2 lists the ONS 15454 Ethernet parameters.
To Next Page
Loading...
