Cisco ONS 15454 - CHAPTER 2 Alarm Troubleshooting; 2.1 Alarm Indexes by Default Severity

15-5
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Chapter 15 Configuring Access Control Lists
Modifying ACL TCAM Size
Modifying ACL TCAM Size
You can change the TCAM size by entering the sdm access-list command. For more information on ACL
TCAM sizes, see the “Configuring Access Control List Size in TCAM” section on page 14-3.
Note To increase the ACL TCAM size, you must decrease another region’s TCAM size, such as IP,
IP multicast, or L2 switching.
Table 15-2 Applying ACL to Interface
Command Purpose
ip access-group {access-list-number | name} {in | out}
Controls access to an interface.