TABLES
xiii
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Table 2-1 ML-Series Ethernet Statistics Fields and Buttons 2-2
Table 2-2 Ethernet Parameters 2-2
Table 2-3 ML-Series POS Statistics Fields and Buttons 2-4
Table 2-4 POS Parameters 2-4
Table 3-1 RJ-11 to RJ-45 Pin Mapping 3-4
Table 3-2 IOS Command Modes 3-11
Table 4-1 Transmission Multiples Supported by ML-Series Cards 4-8
Table 4-2 C2 Byte Common Values 4-9
Table 4-3 Default MTU Size 4-15
Table 4-4 ML-Series Parameter Configuration for Connection to a Cisco 12000 GSR-Series Router 4-20
Table 6-1 Switch Priority Value and Extended System ID 6-4
Table 6-2 Spanning-Tree Timers 6-4
Table 6-3 Port State Comparison 6-10
Table 6-4 RSTP BPDU Flags 6-13
Table 6-5 Default STP and RSTP Configuration 6-16
Table 6-6 Commands for Displaying Spanning-Tree Status 6-20
Table 8-1 Default Layer 2 Protocol Tunneling Configuration 8-7
Table 8-2 Commands for Monitoring and Maintaining Tunneling 8-9
Table 10-1 Default RIP Configuration 10-5
Table 10-2 Default OSPF Configuration 10-10
Table 10-3 Show IP OSPF Statistics Commands 10-20
Table 10-4 Default EIGRP Configuration 10-22
Table 10-5 IP EIGRP Clear and Show Commands 10-27
Table 10-6 BGP Show Commands 10-29
Table 10-7 IS-IS Show Commands 10-31
Table 10-8 Routing Protocol Default Administrative Distances 10-33
Table 10-9 Commands to Clear IP Routes or Display Route Status 10-34
Table 10-10 IP Multicast Routing Show Commands 10-36
Table 11-1 Commands for Monitoring and Verifying IRB 11-5
Table 11-2 show interfaces irb Field Descriptions 11-6
Table 12-1 Commands for Monitoring and Verifying VRF Lite 12-8
To Next Page
Loading...
