1-21
Cisco ONS 15454 Procedure Guide, R4.0
March 2003
Chapter 1 Install the Shelf and Backplane Cable
NTP-A5 Install the Electrical Interface Assemblies
DLP-A14 Install the AMP Champ EIA
Step 1 Align the AMP Champ panel with the backplane and insert and tighten the nine perimeter screws
(P/N 48-0358) at 8 to 10 lb. (3.6 to 4.5 kg).
Step 2 Align an AMP Champ card with the backplane connector and push until it fits snugly. Repeat until you
have installed all six AMP Champ cards.
Step 3 To secure each AMP Champ card to the cover panel, insert and tighten a screw (P/N 48-0003) at the top
of each card at 8 to 10 lb. (3.6 to 4.5 kg).
Step 4 Place the AMP Champ fastening plate along the bottom of the cover panel, and hand-tighten the two
thumbscrews.
Figure 1-8 shows an AMP Champ EIA installation.
Purpose This task installs an AMP Champ EIA.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
9 perimeter screws
12 inner screws
5 backplane cover screws
6 AMP Champ cards
EIA panel
Prerequisite Procedures NTP-A4 Remove the Backplane Covers, page 1-15
Required/As Needed Required if you are using DS1-14 cards and prefer an AMP interface to an
SMB interface
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
