1-55
Cisco ONS 15454 Procedure Guide, R4.0
March 2003
Chapter 1 Install the Shelf and Backplane Cable
NTP-A11 Install the Rear Cover
DLP-A29 Route DS-1 Twisted-Pair Cables
Step 1 Verify the following:
• DS-1 electrical interface adapters are installed on every transmit and receive connector for DS-1
ports.
• Wire-wrap posts on the DS-1 electrical interface adapters are used to connect the terminated
incoming cables.
Step 2 Tie-wrap or lace the twisted-pair cables according to local site practice and route the cables into the side
cutouts on either side of the ONS 15454.
Note SMB EIAs feature cable-management eyelets for tie wrapping or lacing cables to the cover
panel.
Step 3 Return to your originating procedure (NTP).
NTP-A11 Install the Rear Cover
Purpose This task routes the DS-1 twisted-pair cables.
Tools/Equipment None
Prerequisite Procedures DLP-A23 Install DS-1 Cables Using Electrical Interface Adapters (Balun),
page 1-46
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
Purpose The following procedure explains how to install the rear cover.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures None
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
