1-34
Cisco ONS 15454 Procedure Guide, R4.0
March 2003
Chapter 1 Install the Shelf and Backplane Cable
NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections
Step 6 Attach the connector on the opposite end of the cable assembly to the EIA/TIA-485 connector port on
the AEP (Figure 1-13 on page 1-33).
Step 7 Continue with the “NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections”
procedure on page 1-34.
Stop. You have completed this procedure.
NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Step 1 Complete the “DLP-A19 Install Alarm Wires on the Backplane” task on page 1-35 if you are using an
AIC or AIC-I card and not using an AEP.
Step 2 Complete the “DLP-A20 Install Timing Wires on the Backplane” task on page 1-37 as needed. Timing
wires are necessary to provision external timing.
Step 3 Complete the “DLP-A21 Install LAN Wires on the Backplane” task on page 1-38 as needed. LAN wires
(or the LAN port on the TCC+/TCC2) are necessary to create an external LAN connection.
Step 4 Complete the “DLP-A22 Install the TL1 Craft Interface” task on page 1-39 as needed. Craft wires (or
the EIA/TIA-232 port on the TCC+/TCC2) are required to access TL1 using the craft interface.
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf
assembly.
Tip 6 6 AE_CLK_P AE_CLK_P
Tip 7 5 AE_CLK_N AE_CLK_N
Tip 8 4 AE_DOUT_P AE_DIN_P
Tip 9 3 AE_DOUT_N AE_DIN_N
Tip 10 2 AE_DIN_P AE_DOUT_P
Tip 11 1 AE_DIN_N AE_DOUT_N
Table 1-1 Pin Assignments for the AEP (continued)
Wire Pin AEP Signal AIC-I Signal
Purpose This procedure describes how to install alarm, timing, LAN, and craft
wires.
Tools/Equipment Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) alarm wires
Prerequisite Procedures NTP-A4 Remove the Backplane Covers, page 1-15
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
