1-45
Cisco ONS 15454 Procedure Guide, R4.0
March 2003
Chapter 1 Install the Shelf and Backplane Cable
NTP-A9 Install the Electrical Card Cables on the Backplane
NTP-A9 Install the Electrical Card Cables on the Backplane
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Note Refer to the Cisco ONS 15454 Reference Manual for more information about EIAs.
Step 1 Complete the “DLP-A23 Install DS-1 Cables Using Electrical Interface Adapters (Balun)” task on
page 1-46 as needed. Baluns are used on SMB EIAs to properly terminate DS-1 signals.
Step 2 To install DS-1 cables using AMP Champ cables, complete the “DLP-A24 Install DS-1 AMP Champ
Cables on the AMP Champ EIA” task on page 1-47.
Step 3 Complete the “DLP-A25 Install Coaxial Cable With BNC Connectors” task on page 1-50 as needed.
Step 4 Complete the “DLP-A26 Install Coaxial Cable With High-Density BNC Connectors” task on page 1-51
as needed.
Step 5 Complete the “DLP-A27 Install Coaxial Cable with SMB Connectors” task on page 1-52 as needed.
Step 6 Continue with the “NTP-A10 Route Electrical Cables” procedure on page 1-53.
Stop. You have completed this procedure.
Purpose Optional EIA backplane covers are typically pre-installed when ordered
with the ONS 15454. The following procedure describes how to install the
electrical card cables to the backplane. If the shelf was not shipped with the
correct EIA interface, you must order and install the correct EIA.
Tools/Equipment Wire wrapper
Twisted-pair cables
BNC insertion tool
SMB cable connector
Prerequisite Procedures NTP-A5 Install the Electrical Interface Assemblies, page 1-16
Required/As Needed Required if you are using electrical cards
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
