Cisco SCE 8000 User Manual

7-4
Cisco SCE8000 GBE Installation and Configuration Guide
Chapter 7 Basic Cisco SCE 8000 Platform Operations
Final Tests
Verifying Operational Status
After all the ports are connected, verify that the Cisco SCE 8000 is not in a Warning state.
Step 1 On the front panel of the Service Control module, examine the Status LED; it should be green.
Step 2 To display the operation status of the system, at the Cisco SCE 8000# prompt, enter show system
operation-status and press Enter.
A message displaying the operation status of the system appears. If the system is operating in order, the
following message appears:
System Operation status is Operational.
If the Status LED is red or flashing amber, the following message appears:
System Operation status is Warning
Description:
1. Power Supply problem
2. Line feed problem
3. Amount of External bypass devices detected is lower than expected amount
Viewing the User Log Counters
View the user log for errors that occurred during the installation process.
At the SCE8000# prompt, enter show logger device user-file-log counters and press Enter.
Example for Viewing the User Log Counters
The following example shows the current User-File-Log device counters:
SCE8000# show logger device user-file-log counters
Logger device User-File-Log counters:
Total info messages: 1
Total warning messages: 0
Total error messages: 0
Total fatal messages: 0
If there are “Total error messages” or “Total fatal messages”, use the show logger device user-file-log
command to display details about the errors.
Viewing the Ten Gigabit Ethernet Port Status
At the Cisco SCE8000# prompt, enter show interface TenGigabitEthernet 3/ baynumber /0.
This displays the port link status.
The following example displays a system response:
Cisco SCE8000# show interface TenGigabitEthernet 3/1/0
Actual Status:
Link is on
Bandwidth: 10000000Kbps
Burst-size: 500000bytes

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English