Cisco SCE 8000 User Manual

CHAPTER
5-1
Cisco SCE8000 GBE Installation and Configuration Guide
5
Connecting the Management Interfaces
Revised: August 26, 2014
Introduction
This chapter explains how to connect the Cisco SCE 8000 Service Control Module (Cisco SCE
8000-SCM-E) to a local console and perform the initial system configuration.
Additionally, this chapter contains instructions for cabling the 10/100/1000 Ethernet management
interfaces.
The Console interface (CON) as well as the management interfaces (Port1 and Port2) are located on the
Cisco SCE 8000-SCM-E located in slot 1 of the Cisco SCE 8000 chassis (see the ““Service Control
Module (Cisco SCE 8000-SCM-E)” section on page 2-4”.
This chapter contains the following sections:
• How to Set Up the Local Console, page 5-2
• Initial Setup Parameters, page 5-3
• Connecting the Management Interfaces, page 5-5

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English