Cisco SCE 8000 User Manual

C-4
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Error Messages, Severity Level 3
Fatal Message SIMBA_USR_HW_MONITOR_FATAL "<%s>: <%s> hardware monitor status is
FATAL
Explanation
This message is displayed when a fatal error occurs in any of the corresponding
hardware modules.
Recommended Action None.
Error Messages, Severity Level 3
Common Error Messages
Common Error Message %LOCAL7-3-SE_USER_ERROR "SE %s Module: An Error occurred. Please
report to Cisco's customer support"
Explanation
This error message is generated when one of the following scenarios occur:
– The hardware monitor sanity check fails.
– When there is an error in a partition, the ControlCard watchdog timeout handler, and so on.
Recommended Action Generate the support file and contact Cisco Customer Support.
Common Error Message %LOCAL7-3-"NOT_ENOUGH_MEMORY "Partition init - not enough
memory. Required = %lu + %lu for sys heap, Available = %lu\n Memory will be
adjusted"
Explanation
This message is displayed when there is insufficient memory for allocating a new parent
block from the VxWorks heap.
Recommended Action None.
Common Error Message %LOCAL7-3-FAILED_TO_ALLOCATE_MEMORY "Part init - failed to
allocate the parent block. size = %lu"
Explanation
This message is displayed when there is a failure to allocate memory for the parent
block, and the log displays the parent block size.
Recommended Action None.

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English