C-3
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Fatal Messages, Severity Level 2
Fatal Message %LOCAL7-2-LIC_CRASH_FATAL "HW internal error: LIC Interrupt - bypass
wd not working in crash mode."
Explanation
This is an internal hardware error that occurs when bypass does not work in the crash
mode, and a linecard interrupt occurs.
Recommended Action None.
Fatal Message %LOCAL7-2-GENERIC_FATAL "A problem occurred in the <%s> ,Please report
to Cisco's customer support."
Explanation
This message is displayed in a user’s log when a generic fatal error occurs.
Recommended Action None.
Fatal Message %LOCAL7-2-MSG_HANDLER_READING_FROM_Q_FAILED "SW internal error:
failed reading from message queue"
Explanation
This fatal message is displayed when the remote procedure call (RPC) message handler
fails to receive a message from the corresponding queue.
Recommended Action None.
Fatal Message %LOCAL7-2-READING_FROM_Q_FAILED " SW internal error - Failed to read
from receive queue number %d, from ppc: %d, to ppc: %d, queue: %d."
Explanation
This fatal message is displayed when failure to read a message from a queue number
with a traffic processor and queue details occurs.
Recommended Action None.
Fatal Message %LOCAL7-2-TOO_MANY_MSGS_FROM_SINGLE_QUEUE "SW internal error -
Received %d consecutive messages from queue number %d, from ppc: %d, to ppc: %d,
queue: %d."
Explanation
This fatal message is displayed when more than 400 messages exist in a single queue.
Recommended Action None.
Fatal Message %LOCAL7-2-READING_FROM_Q_FAILED "A SW error occurred. Please report to
P-Cube's Customer Support"
Explanation
This message is displayed when the line card handler fails to read a message from the
corresponding queue.
Recommended Action None.
To Next Page
Loading...
Need help?
General
