Cisco SCE 8000 User Manual

CHAPTER
9-1
Cisco SCE8000 GBE Installation and Configuration Guide
9
Removal and Replacement Procedures
Revised: August 26, 2014
Introduction
This chapter describes how to perform removal and replacement procedures for Cisco SCE 8000
platform field-replaceable units (FRUs).
Note Before you install, operate, or service the system, read Regulatory Compliance and Safety Information
for the Cisco Service Control Engines (SCE). This guide contains important safety information you
should know before working with the system.
This chapter contains the following sections:
• Safety, page 9-2
• Preventing Electrostatic Discharge Damage, page 9-3
• Supported Hardware, page 9-3
• Removing and Replacing the Power Supply, page 9-4
• Removing and Replacing the Fan Assembly, page 9-13
• Removing and Replacing Modules, page 9-15
• Removing and Replacing Shared Port Adapters, page 9-29
• Removing and Replacing the Optical Bypass Module, page 9-33

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English