7-6
Cisco SCE8000 GBE Installation and Configuration Guide
Chapter 7 Basic Cisco SCE 8000 Platform Operations
Managing Cisco SCE 8000 Configurations
Managing Cisco SCE 8000 Configurations
After you have installed your Cisco SCE 8000 platform hardware, checked all external connections,
turned on the system power, and allowed the system to boot up, you are ready to install the Service
Control application. However, before you install the application, you might need to configure the SCE
platform. Instructions for configuring the Cisco SCE 8000 platform are beyond the scope of this
publication.
For further information on system and interface configuration, see the following documents:
• Cisco SCE8000 10GBE Software Configuration Guide
• Cisco SCE8000 CLI Command Reference
The procedures for managing Cisco SCE 8000 configurations are explained in the following sections:
• Viewing Configurations, page 7-6
• Saving or Changing the Configuration Settings, page 7-8
• Restoring a Previous Configuration, page 7-9
Viewing Configurations
When you enter configuration commands, it immediately affects the SCE platform operation and
configuration. This configuration, referred to as the running-config, is saved in the SCE platform volatile
memory and is effective while the SCE platform is up. After reboot, the SCE platform loads the
startup-config, which includes the non-default configuration that was saved by the user, into the
running-config.
The SCE platform provides commands for:
• Viewing the running configuration with only user-configured (non-default) values: show
running-config
• Viewing the running configuration with all the SCE platform running configuration values, whether
default or not: show running-config all-data
• Viewing the startup configuration: show startup-config
To Next Page
Loading...
Need help?
General
