Cisco SCE 8000

C-30
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-MODULE_OPER_STATUS_CHANGE : "<%s>"
Explanation
This trap is generated to indicate the update redundancy status.
Recommended Action None.
Error Message %LOCAL7-6-MODULE_OPER_STATUS_CHANGE: "<%s>"
Explanation
This SNMP trap is generated when a module’s operational status is changed.
Recommended Action None.
Error Message %LOCAL7-6-MODULE_LOST_REDUNDANCY:"<%s>"
Explanation
This SNMP trap is generated when module redundancy is lost in Cisco SCE.
Recommended Action None.
Error Message %LOCAL7-6-MODULE_REDUNDANCY_CONF_MISMATCH:"<%s>"
Explanation
This SNMP trap is generated when there is a mismatch in the configuration with module
redundancy of Cisco SCE.
Recommended Action None.
Error Message %LOCAL7-6-REMOVED_KEYS: "SSH keys were removed."
Explanation
This message is generated when the SSH keys are removed successfully.
Recommended Action None.
Error Message %LOCAL7-6-SESSION_ACCEPTED:"A telnet session from <%s> was
established."
Explanation
This message is generated when a telnet session is started successfully.
Recommended Action None.
Error Message %LOCAL7-6-SESSION_DENIED:"A telnet request from <%s> was denied - IP
address not in ACL."
Explanation
This message is generated when a telnet access is denied because of the corresponding
IP address not being available in the Access Control List (ACL).
Recommended Action None.