Cisco SCE 8000

C-40
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-VAS_HC_SERVER_LOG_EVENT_NO_VLAN: "Vas Health Check Monitor
Explanation
This message is generated when Cisco SCE is unable to run the VAS health check
monitor for a given VAS server because the VLAN tag for the server is missing.
Recommended Action None.
Error Message %LOCAL7-6-VAS_HC_MONITOR_SET_FF_RULE : "Handling all UDP traffic in IP
range of 0x%x
Explanation
This message is displayed when you set the flow-filter configuration of the VAS health
check for the UDP traffic in a given subscriber-side IP range.
Recommended Action None.
Error Message %LOCAL7-6-VAS_HC_MONITOR_CLEAR_FF_RULE : "Removed special handling of
all UDP traffic in IP range of 0x%x
Explanation
This message is displayed when you set the flow-filter configuration of the VAS health
check for the UDP traffic in a given subscriber-side IP range.
Recommended Action None.
Error Message %LOCAL7-6-LC_INIT_COMPLETED: "General RuC initialization completed"
Explanation
This debug message is displayed when linecard initialization is completed.
Recommended Action None.
Error Message %LOCAL7-6-RUC_INIT_COMPLETED: "RuC specific initialization completed"
Explanation
This debug message is displayed to indicate that the initialization of a specific Traffic
Processor or Master Processor is completed.
Recommended Action None.
Error Message %LOCAL7-6-CPLD_POWER_BOOT: "Power-down boot identified (CPLD)"
Explanation
This debug message is displayed on a user log when the complex programmable logic
device (CPLD) powers up successfully.
Recommended Action None.
Error Message %LOCAL7-6-DUMMY_USER_INFO: "Dummy Info User Message"
Explanation
This is a dummy user informational message.
Recommended Action None.